Walk onto the bridge of any ocean-going ship and you’ll find a wall of radios. They aren’t spares. Each one is there because radio waves behave differently on different frequencies, and a ship has to be able to call for help whether it’s in the harbour or halfway across the Pacific. Here’s what each one does, from the shortest reach to the longest.
Why one radio can’t do it all
A radio signal can take three different paths from one antenna to another. Which path it takes depends almost entirely on its frequency. That’s why a ship needs more than one kind of radio.
VHF: straight to the horizon
VHF signals travel in a straight line, like light. The earth curves away underneath them, so beyond the horizon they carry on into space. That’s why antenna height matters so much. The radio horizon in kilometres is roughly 4.1 × the square root of each antenna’s height in metres, added together. A ship’s antenna 20 m up talking to a coast station 100 m up gets you about 60 km. A small boat with its antenna 2 m off the water reaches only a few kilometres.
MF: following the curve
Lower frequencies have longer waves, about 150 m at 2 MHz. Waves that long “drag” along the surface and bend to follow the curve of the earth. This is the ground wave. Salt water is an excellent conductor, so MF ground wave goes much farther over the ocean than over dry land.
HF: bounced off the sky
Between about 80 and 400 km up, the sun’s ultraviolet light knocks electrons loose from the thin air, forming the ionosphere. When an HF signal goes up into it, the signal is bent (refracted) a little at a time, like light through water, until it turns and comes back to earth thousands of kilometres away. It can bounce off the sea and go up again, hopping around the world.
A bit of history: When Guglielmo Marconi received a radio signal from England at Signal Hill in St. John’s, Newfoundland, in December 1901, nobody could explain how it got around the curve of the earth. The next year, Arthur Kennelly in the United States and Oliver Heaviside in England each suggested a conducting layer high in the atmosphere. The E layer is still sometimes called the Kennelly–Heaviside layer. British physicist Edward Appleton proved it was there in 1924, and he later won the Nobel Prize in Physics for his work on the ionosphere.
- Lower frequencies bend more and come down closer. Higher frequencies bend less, so they come down farther away, until at some point they don’t bend enough and pass right through into space. The highest frequency that still comes back is called the maximum usable frequency (MUF).
- The skip zone. Between where the ground wave fades out and where the sky wave first comes down, there’s a gap where the signal can’t be heard at all.
- Day and night change everything. In daytime the low D layer soaks up the lower frequencies, so ships use the higher HF bands. At night the D layer disappears, so the lower bands open up for long distances. That’s why ship HF radios have several bands, and why the DSC distress frequencies are spread across them.
Put it together and you have a ship’s radio room. VHF is clear and reliable close in. MF carries past the horizon over the water. HF reaches across an ocean when the ionosphere co-operates. Satellites cover whatever is left.
Watch: why ships carry three different radios
This short video from the Still Onboard channel does a very good job of showing how frequency, distance and the curve of the earth decide which radio a ship uses.
1. VHF: the everyday radio
This is the radio you hear most on the bridge. VHF marine radio works around 156 MHz and travels in a straight line, so its reach depends on how high the antennas are. Ship to shore, expect about 74 km (40 nautical miles).
- Channel 16 (156.8 MHz) is the international distress, safety and calling channel. Canadian Coast Guard Marine Communications and Traffic Services (MCTS) centres listen to it around the clock, every day of the year.
- Channel 70 (156.525 MHz) is for Digital Selective Calling (DSC) only. No talking is allowed there. Press the red distress button on a DSC radio and it sends the ship’s identity and GPS position in a burst of data, then switches to channel 16 for voice.
- Channel 13 is used bridge to bridge so ships can agree how they’ll pass each other, and channel 6 is for ship-to-ship safety calls.
The VHF set also runs AIS (Automatic Identification System). Every few seconds the ship broadcasts its name, position, course and speed, so other ships see it on their screens.
2. MF: the middle-distance workhorse
Once a ship is out of VHF range, medium frequency (MF) takes over. MF works around 2 MHz and travels by ground wave, hugging the curve of the earth past the horizon. That gives it a reach of roughly 280 km (150 nautical miles) from a coast station.
- 2182 kHz is the MF voice frequency for distress and calling. Canadian Coast Guard MCTS centres listen to it 24 hours a day.
- 2187.5 kHz is the MF channel for DSC distress alerts.
- NAVTEX on 518 kHz is also in the MF range. It’s a receiver that automatically prints weather forecasts, ice reports and navigation warnings sent by the Coast Guard.
For hams: 2 MHz sits just above our 160-metre band (1.8 to 2.0 MHz), and it behaves the same way. It goes much farther at night, gets noisy with summer static, and needs a big antenna to work well.
3. HF: across the ocean
High frequency (HF), from about 4 to 22 MHz, is the radio for the open ocean. HF signals bounce off the ionosphere and come back down thousands of kilometres away, the same skywave propagation hams use to work the world. The ship picks the band that suits the time of day and the distance, just as a ham does.
There are DSC distress frequencies on several bands: 4207.5, 6312, 8414.5, 12577 and 16804.5 kHz. That way an alert gets through whatever the ionosphere is doing.
4. Satellite and the automatic safety kit
Satellites cover what radio can’t. Inmarsat satellites cover the oceans from about 70° north to 70° south, and Iridium has also been approved for distress use, reaching right up to the poles. Alongside them, every ship carries some radios that work on their own:
- EPIRB (Emergency Position-Indicating Radio Beacon). If the ship sinks it floats free, switches on by itself and sends a 406 MHz signal to the Cospas-Sarsat search-and-rescue satellites. Canada is one of the founding countries of that system.
- SART (Search and Rescue Transponder). Kept in the lifeboat, it answers a searching ship’s or aircraft’s radar, showing up on the screen as a line of dots that points straight to the survivors.
How it all fits together
All of this is organised under the Global Maritime Distress and Safety System (GMDSS). It divides the world’s waters into four sea areas:
- A1: within VHF range of a coast station.
- A2: within MF range.
- A3: within satellite coverage.
- A4: the polar regions beyond that.
The farther a ship sails, the more of these radios it must carry. The whole system was designed so that a distress call gets through automatically, even if nobody happens to be listening on the right channel at the right moment.
Can a ham just pick up the mike?
Not on the marine channels. In Canada, using a marine radio requires the Restricted Operator Certificate – Maritime, ROC(M), which is separate from your amateur certificate. The course and exam are offered through CPS-ECP (Canadian Power and Sail Squadrons). Many hams hold both.
Hams do have their own place at sea. An amateur operating from a boat signs /MM (maritime mobile), and HF maritime mobile nets have relayed messages and helped in emergencies for decades.
Boating closer to home? Even on inland lakes, a VHF radio with DSC is a better safety tool than a cell phone. A radio call is heard by every boat nearby, not just one person. Where there’s cell coverage on Canadian waters, dialling *16 connects you to the Coast Guard.
Learn more
- Canadian Coast Guard: Global Maritime Distress and Safety System
- Canadian Coast Guard: Radio Aids to Marine Navigation
- Environment Canada marine forecasts
Questions or ideas about this post? Email us at help@drhd.com. We read every one.